Sameday & next day despatch

Reliable, trustworthy & experienced

5 star rated
customer service

Competitive pricing, high quality products

LATEX 3D SOCKS (Pair)

£13.74 – £20.94 incl. VAT (£11.45 – £17.45 excl. VAT)

If you choose Apply inside or Outside (PRE-GLUED)socks , please follow instruction below;

  • Instructions to Replace Socks All you need to find piece of cardboard or chipboard large enough to fit inside the suit in order to hold the ankle as flat as possible. Cut off perished or torn seal from the connection point to drysuit leg( just under tape-leave 2cm). Turn to suit  inside-out, if you mounting the socks inside of leg .Put the seal through over inside suit tape (2cm over).Apply the seal by applying heat to activate the glue (don't forget lay a piece of cloth on socks) and then use a seam roller for a good pressure down, after that check edges if its coming away ,not stick strongly then apply 15-20sec heat again and give a good pressure with seam roller. After you applied heat for both sides of leg Now,you should rotate your cardboard 90degrees for missed piece at the end.Don't start pulling the seal after job done 🙂 because still glue will be hot just let it cool down for couple of hours.

NOTE: If you using domestic IRON turn steam function off(no water) and need full heat .Don't forget to put a piece of cloth lay over the seal while you applying heat on it

  • SMALL 36.38 -- MEDIUM 39.41 -- LARGE 42.43 -- EXTRA LARGE 44.47

 

Additional information

Weight 0.232 g
Size

SMALL, MEDIUM, LARGE, EXTRA LARGE

PRE-GLUED

No thanks, just the seal itself, Apply Inside +6.00, Apply Outside +6.00

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Happy customers

Subscribe to the newsletter